H2T - Case for Heltec T114 with GPS running Meshtastic®
H2T - Case for Heltec T114 with GPS running Meshtastic®
Couldn't load pickup availability
A GPS enabled Meshtastic® case for the Heltec T114 board with GPS module. Unique 3D printed design, now in ASA for ultimate UV and heat resistance. Install the buttons, board, GPS module, SMA Pigtail and snap the 2 halves of the case together. Secure with (included) screw for a rock solid enclosure.
Fits:
- Battery up to 8mm x 31mm x 60mm
- U.FL to SMA Pigtail 10cm long
- Your choice of SMA antenna up to 12.7mm in diameter at the base
Recommended component kit:
https://muzi.works/products/heltec-t114-kit
Dimensions:
- 50.9mm x 72.7mm x 19.7mm [2.00in x 2.86in x 0.78in]
- 27g [0.95oz]
What's included:
- Case Front, Case Back, Buttons, Black Stainless Steel Screw (2.5mm Hex Drive), Assembly Instructions
Meshtastic® is a registered trademark of Meshtastic LLC. Meshtastic software components are released under various licenses, see GitHub for details. No warranty is provided - use at your own risk.
Share
Great fit and finish
It is a nice case as cases go, but it is hard to tighten the antenna to make sure you have a good connection.
These should be mass-produced.
Great quality. Just wish it would have inlcuded the t10 torx driver.
Bought this case for an Amazon special T114 that came with a lack luster enclosure.
This thing is solid. Great print quality. Easy to follow instructions for assembly. Fit the belt clip holster perfectly. Couldn't have asked for better.
Liked it so much, I ordered a complete H2T kit for the Mrs. And will probably order one more before I consider my collection complete.
Shipping was quick, and customer support is quick to respond to any questions you might have.
Looking forward to having these guys hang from our packs while up in the mountains.